Aeg l14850 manual instructions

Remove the conditioner insert from the middle compartment. Clean all parts with water. Put the conditioner insert in as far as it will go, so that it is firmly in place. Clean all parts of the washing ma- chine, especially the nozzles in the top of the washing-in chamber, with a brush. Page 37 Care and cleaning 4. Place a container close to the pump to collect any spillage. Release the emergency emptying hose, place it in the container and remove its cap. When no more water comes out, unscrew the pump and remove it.

Always keep a rag nearby to dry up spillage of water when removing the pump. Page Water Inlet Filter Care and cleaning 7. Remove any objects from the pump impeller by rotating it. Put the cap back on the emergency emptying hose and place the latter back in its seat.

Screw the pump fully in. Close the pump door. When the appliance is in use and depending on the programme selected there can be hot water in the pump. Close the water tap and unscrew the water inlet hose from the tap. Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out. What to do if Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer.

Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the yellow pilot light of button flashes, one of the following alarm codes appears on the display and at the same time some acoustic Page 41 What to do if The drain hose is squashed or kinked.

The drain filter is clogged. Page 42 What to do if The door lock has not been released. There is water in the drum. Page Technical Data What to do if Anti-flooding system has activated.

Page Installation Installation Installation Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

Page 46 Installation 4. Unscrew and remove the two large rear bolts B and the six smaller bolts C. Remove the bracket D and refit the six smaller bolts C. Slide out the relevant plastic spacer E. Open the porthole, take out the inlet hose from the drum and remove the polystyrene block fitted on the door seal.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Before placing it on small tiles, apply a rubber coating.

Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. Installation should comply with local water authority and building regulations requirements.

Page 49 Installation When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. Page In The Interest Of The Environment Installation In the interest of the environment Washing machines should be connect- ed to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being dis- charged safely into a river.

It is essential that these appliances are not connected to the surface water drainage system as this water is dis- charged directly into a river or stream The power supply cable must be easily accessible after installing the machine. Page Environmental Concerns Environmental concerns Environmental concerns Packaging materials The materials marked with the symbol are recyclable.

Old machine Use authorised disposal sites for your old appliance. Help to keep your country tidy! The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Page 53 Notes Page 54 Notes Page 55 Notes Page 56 www.

Print page 1 Print document 56 pages. Rename the bookmark. Delete bookmark? To avoid this, pleas e check inside the drum before using. Damage to the fabric can ensue if you over-fill. Refer to the manufacturer's recommendations of quantities. Repairs carried out by inexperienced persons may cause injury or serious.

Contact your local Service Centre. Always insist on genuine spare parts. If in doubt, do not use it and contact the Service Centre. Serious damage can occur to the product. See relevant section in the user manual. It must not be used for purposes other than those for which it was designed.

Follow the instructions on each garment label.